Purolyt is an innovative German product that has an incredible set of ingredients that react in a way that allows you to prevent or terminate any kind of bacteria, fungi or microscopic being that may be harmful to your plants. 

Cuttings producers

  1. disinfect your hands – 1:50 dilution
  2. disinfect your equipment (scalpels, scissors etc.)  – 1:50 dilution
  3. disinfect your cutting plugs by soaking them –  1:100 dilution
  4. disinfect your mother plants  by spraying them  1:50 dilution
  5. when cutting the cuttings from the mother plant, immediately place them in dilution for 1-24 hrs  -1:50 dilution

Combination with all rooting aids possible

Propagation: Cultivators of clones and seedlings

  1. prepare a 1:50 dilution (please keep in mind that the dilution should be used as soon as possible, in any case within 48 hours). Store dilution in airtight container and keep it out of direct UV.
  2. when using seeds, soak them in this solution for 8-24 hours
  3. once per day lift the lit of the propagator and spray the seedlings/cuttings until dripping wet
  4. allow to dry and close lit again, repeat the process next day

Indoor growers (growth and bloom – the whole cycle)

  1. prepare a 1:50 dilution (please keep in mind that the dilution should be used as soon as possible, in any case within 48 hours. Store dilution in an airtight container and keep it out of direct UV light
  2. 2-3 times a week spray 1:50 dilution directly on the plants in order to protect them from pathogens and to boost their immune system (priming effect)

IMPORTANT NOTES INDOOR GROWING:

  • In case of acute infestations (e.g mildew), the doses can be significantly increased for a short, limited period; doses up to 1:4 dilution (250 ml purolyt + 750 ml water) are no problem for the plants
  • Spraying and fogging should be always performed in the end of a lighting phase, with reduced light quantities. (avoid direct sunlight/UV-light)
  • For spraying, commercially available pressure sprayers (min. 3 bar) are suitable. An ideal contribution is achieved by cold fogging. it is highly recommended to use the preventive application.
  • Another well-established method of prevention is a permanent addition to the water reservoir of humidifiers (does not work in combination with CMH lamps because the percentage of UV light is too high) Purified water should always be used for spraying and fogging applications (e.g. distilled water, deionized water or osmosis water).

Hydroponic growers (DWC)

  1. For preventive use add 5-10 ml to 10 liters of water directly into the water
  2. To treat an already existing contamination, add 20- 40 ml to 10 liters of water directly into the water. Both treatments can be applied during normal operation of the hydroponic system, while plants are in the system. Expert advice: since pathogens such as bacteria, funghi and viruses are spread over the irrigation water, clean and germ-free water is top priority!

IMPORTANT NOTES FOR HYDROPONICS (DWC)

  • At water temperatures lower than 23 Celsius (74 Fahrenheit), use lower dose once a week
  • At water temperatures higher than 23 Celsius (74 Fahrenheit), use higher dose twice a week
Purolyt application